Use this bar to show information about your cookie policy.
Roll over image to zoom inClick on image to zoom
/
Description
35w Powertronic Ballast - Osram - PTFIT35I
Product family benefits
ECG with ergonomic strain relief for correct installation in suspended ceilings
Optimized cost/benefit factor
Automatic safety shutdown of lamps in the event of a defect or at end of life (EoL)
Areas of application
Shop lighting
Health and fitness areas (in luminaires with protection class IP66 or higher)
Effect and accent lighting
Safety advice Ballast losses and lamp heat radiation can lead to heat accumulation in a completely closed case. Therefore it is necessary to ensure that the temperature at the measuring point t of the ECG does not exceed the maximum value. Attention! For safety reasons disconnect the device before replacing the lamp!
Technical Data
Electrical data
Lamp wattage
39 W
Maximum output power
39 W
Line current
0.19 A
Ignition voltage
4.5 kVp
Operating frequency
0.200…0.240 kHz
System wattage
43.00 W
Efficiency in full-load
91 %
Input voltage AC
198…264 V
Nominal voltage
220…240 V
Mains frequency
50…60 Hz
Power factor λ
0.95
Inrush current
30 A
Max. ECG no. on circuit breaker 10 A (B)
15
Max. ECG no. on circuit breaker 16 A (B)
26
Max. no. of ECGs on 16A MCB with EBN-OS
65
Protective conductor current
0.3 mA
U-OUT (working voltage)
250 V
Max. working voltage between LH and LL
250 V
Max. working voltage betw. LL/LH & earth
250 V
Max. capacitance of wire ECG/lamp
120 pF
Dimensions & weight
Length
172.0 mm
Width
83.0 mm
Height
33.0 mm
Mounting hole spacing, length
163.0 mm
Cable cross-section, input side
0.75…1.5 / 0.75…2.5 mm²
Cable cross-section, output side
0.75…1.5 / 0.75…2.5 mm²
Wire preparation length, input side
5.5…6.5 mm
Wire preparation length, output side
5.5…6.5 mm
Product weight
285.00 g
Colors & materials
Casing material
Plastic
Temperatures & operating conditions
Ambient temperature range
-15…+60 °C
Maximum temperature at tc test point
75 °C
Lifespan
ECG lifetime
30000 h
Additional product data
Design / version
With cable clamp
Suitable for lamp power (1 lamp)
39 W
Capabilities
Max. cable length to lamp/LED module
1.5 m
Overheating protection
Power reduction and switch off at T > 75 °C at the tc point